Ep 09 First Upgrades Hypercube Evolution

Summary

In this video I take a look at setting up the BL Touch sensor for use with the BigTreeTech SKR V1.3 board on the printer. Actually I ... This time I am looking at getting the heat bed and hot end wired up on the controller board and making the required changes to ... Calibration Part by MrTestOne: thingiverse.com/thing:1815784 My Parameters tested with PETG from DasFilament: ... After 2 years of full on usage my HEVO was showing some signs of wear with thermal issues and some Z banding due to the Z ... Ok so I've tidied up the wiring somewhat and started to look at getting decent prints off the printer. The for more to see this in my next full upcoming videos. In this video I just want to touch on what I have planned for the This finalises the hardware install and setup of the Titan Aero extruder. So in my last video I described an issue where I have seen a few prints coming off with the geometry all over the place. I had to change the belts on the This is part 1 of Rebuilding my HEVO, it will have brand new updated coreXY system and new Voron Stelthburner with clockworks ... This is the third in the series of my I've been sick over the past little bit so haven't managed to progress too far however I have managed to get a few things sorted ...